It comprises of micro controllerand an integrated transceiver for processing,sending and receiving data.

• 32-bit RISC j N5168 microcontroller
• 1-32 MHz dock speed
• 256KB flash, 32KB RAM, 4KB EEPROM
• 2.4 GHz IEEE 802.15.4 compliant radio
• 128-bit AES security processor
• Integrated PCB Antenna
• Rx current 17mA, Tx current 15mA
• 2V to 3.6V battery operation
• Controllable transmission power (-32 to 0 dBm)

It programs themicrocontroller and acts as an interfacebetween the network and PC.

• USB to Asynchronous serial data transfer interface
• USB protocol handled by the device(No USB specific programming required
• Data transfer rate 115200 baud
• 128 byte receive buffer and 256 byte transmit buffer

• Low power WiFi networking module
• Integrated SPI serial flash for software
• Broadcom BCM433362 single band 2.4 GHz IEEE 802.11 b/gin 1x1 Win transceiver
• Includes support for all WiFi security modes including Open, WEP, WPA, WPA2-PSK
• Integrated 1MB flash memory and 128KB SRAM
• WiFi power save: 0,77 mA
• Active receive: 6.9mA @ 1 Mbits/s
• Active transmit: 12.5mA @ 1 Mbits/s

• IEEE 802.3 compatible ethernet controller
• 8KB transmit/receive packet dual port SRAM
• Configurable transmit/receive buffer size
• Fully compatible with 10/100/1000 Base-T Networks
• Integrated with SENSEnuts Radio module with 5PI interface

This module measures the temperature and light intensityfor environment monitoring

• Temperature Range: -25°C to 80°C with 12-bit resolution
• Light Range 3 to 64K Lux with 16-bit resolution and excellent IR/UV rejection
• 1.5uA shutdown current

It provides the complete solution for motion andpositioning applications. It houses a GP5 transceiver with an integrated antenna,an accelerometer and an interface for a FIR sensor

• NMEA 0183 (2.3, compatible to 3.0) protocol output for GP5
• ±2G/±4G/±8G dynamically selectable full scale acceleration
• 14-bit and 8-bit digital output for accelerometer
• PIR with extreme low current consumption

It enables an application designer to implement a weather orenvironment specific application with minimal efforts. Sensor HTP is capable of gatheringthe information of relative humidity, barometric pressure and ambient temperature.

• The humidity sensor provides digital output with a 14-bit resolution (0.04 % RH)
• The pressure sensor outputs the Barometric pressure in 24-bit resolution

It supports QVGA1160*120 resolution output in JPEG.

• It supports standard baud rates from 9600 to 115200 baud
• Current consumption of 80mA

It extends all the pins of the micro controller on RadioModule and provides access to users, if needed. This makes it easier to

• Connect external sensors,devices & create external control circuitry
• Debug hardware/checking output on DlOs and other ports
• Access to ADC, SP{, UART, l2C and PWM generators

• Concentration detection 350 to 10000 ppm for CO2 and 20 to 2000 ppm for CO
• input voltage requirements: 6 Volts
• Current requirement 200mA
• Operating temperature - 20 to 70 degrees celcius